VIC1610 — VIC Laser Cutting Machine

The VIC1610 working area gives 1600mm in the first table dimension and 1000mm in the second. VIC1318 changes those entries to 1300mm and 1800mm. A layout that depends on one dimension should be reviewed against the complete area, with its intended orientation shown. A model name by itself cannot communicate that requirement.

The VIC structure is described through a CO2 cutting head and tube, linear guides, stepper motors and belt drive. Those component groups can organize your equipment comparison. Ask the quotation to identify the offered specification for each group and to keep any proposed alternatives visible, rather than compare only the model designation.

The equipment table gives 0.01mm Position Accuracy and 0.02mm Repetition Accuracy. It also lists ≤0.15mm for Min Line Width. Preserve the original labels when passing the specifications to your engineering team. Requirements for the finished part belong on its drawing and need their own discussion with the proposed machine setup.

Imagine a buyer choosing between a wider arrangement of parts and a longer arrangement on the incoming material. Send both layouts if both remain possible, and label the outside dimensions of each. That is more informative than asking whether VIC1610 or VIC1318 is bigger; the answer needed for purchasing concerns the actual arrangement.

Separate the incoming blank from the finished geometry in the inquiry. Give material description, thickness, quantity and drawing revision for the work you want assessed. If later operations impose a tolerance or edge requirement, mark it. These are application requirements to discuss, rather than evidence that any proposed job has already been demonstrated.

The VIC table offers Knife Table or Honeycomb Table. Its configuration text describes an aluminum blade worktable for the knife option. Tell the supplier which surface you want considered and have the offered table identified in writing. The two alternatives should not be read as a promise to include both with one machine.

A red-dot pointer is optional. It projects a visible point for positioning material, and its inclusion can be requested separately. Keep that request together with the selected laser power and table choice so that changes to the proposal can be checked item by item before the equipment list is agreed.

The control entry is Ruida with USB interface; listed graphic formats include PLT, DXF, BMP, JPG and AI. Send a representative file with units and revision identified. For electrical planning, state the destination supply: 220V/50HZ and 110V/60HZ are the two published entries, not a statement of automatic dual-voltage operation.